Wheels

[kingpin]

Looking for new nibral wheels for my 28 CC 4btas 250 HP... any ideas... I have 17x19 4 blades...

[Nutz]

Acme Propellers in Michigan. I ordered a pair from them thru CC.

[kingpin]

wheels

what size did you go for...? Do you have the 4btas?

[Nutz]

I have the 6B's. I bought a set of 17x20's. My old props were 17x21 and Acme recommends going down an inch in pitch as their blades have a larger surface area. If you call Acme they will be able to figure out what you will require. I will say it did improve my top end alot but it is a little slow to come out of the hole. I have a 1:1.23 gear which makes it harder to begin with. When I pull the boat next time I will probably get them repitched to 19" and have a little more cup added in hopes of getting up faster and keeping top end where it is now. My problem now is getting the motors to turbo speed. Once there she jumps out of the water and takes off.

[CClassic28]

I had a pair of 17 x 20 Acme wheels on my 28 with 4bta 250 Cummins. If you contact Bill Weeks at Acme he will set you up perfectly.

Good Luck,

Chris