If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I'm mounting a set of Lee Juniors on a 25CC. Does anyone know what sort of backing is required? Is it necessary to bolt all the way through, or just through the outside fiberglass. Thanks.
Hi Seamoor,
I installed a pair of Lee Juniors about 8 years ago on my 25CC. As I recall the only location to install a backing plate on my 96 was in the deck area. In the side wall area which holds the lock down assembly I was only able to install several large SS wood screw. I know Mac has changed the interior of the helm area and you may be able to install some plates in other areas. To help relieve any pressures on the wood screw while in the stored position I have a small line tied between the rigger and the hardtop. Good luck with the installation and sent a picture of the installation.
Capttom1
Comment