Tweet
My ACME props came in this weekend and while I had the boat out of the
water for the install I decided to pull the plug and drain the bilge.Good thing
I did it practicully fell out of the hull when I went to remove the plug, two
screws were hardly touching the hull they had been installed angleing in
towards the bilge hole leaving one screw to secure the fitting and that screw
would not tighten.That fitting must have been installed on a friday afternoon!
Installed new props and new fitting all is well props work great.
Just wanted you guys to check your bilge drain through hull..
2000 28 CC
water for the install I decided to pull the plug and drain the bilge.Good thing
I did it practicully fell out of the hull when I went to remove the plug, two
screws were hardly touching the hull they had been installed angleing in
towards the bilge hole leaving one screw to secure the fitting and that screw
would not tighten.That fitting must have been installed on a friday afternoon!
Installed new props and new fitting all is well props work great.
Just wanted you guys to check your bilge drain through hull..
2000 28 CC