After 2 days of work, Tony & I have accomplished a few things:
1. depth/temp smart sensor thru hull is faired & cut on the keel line aft, near the rear bilge pump
2. The thru hull underwater light housings have been installed
3. 2-16' digital antennas mounted
4. 3-GPS antenna mounts installed on buggy top
5. Radar array, partially mounted, signal cable routed thru hardtop, tower leg & back to helm (what a bitch!)
6. Helm dash cut out to accept custom teak panel (thanks Tom!)
7. AP 26 autopilot head installed, relocated fuel gauge to above throttle
8. VHF radio & external speaker mounted, AM/FM radio remote relocated to top of dash
9. ACR spotlight control mounted
10. microwave removed & 3 circuit A.C. panel mounted & 8 circuit D.C. panel mounted.
Lots more to do...just figured I'd give you guys an update. Pics attached!!
Chris
1. depth/temp smart sensor thru hull is faired & cut on the keel line aft, near the rear bilge pump
2. The thru hull underwater light housings have been installed
3. 2-16' digital antennas mounted
4. 3-GPS antenna mounts installed on buggy top
5. Radar array, partially mounted, signal cable routed thru hardtop, tower leg & back to helm (what a bitch!)
6. Helm dash cut out to accept custom teak panel (thanks Tom!)
7. AP 26 autopilot head installed, relocated fuel gauge to above throttle
8. VHF radio & external speaker mounted, AM/FM radio remote relocated to top of dash
9. ACR spotlight control mounted
10. microwave removed & 3 circuit A.C. panel mounted & 8 circuit D.C. panel mounted.
Lots more to do...just figured I'd give you guys an update. Pics attached!!
Chris
Comment